Controls And Indicators - NAPCO MAGNUM ALERT-725 Operating Manual

NOTE: Circled numbers below are keyed to
those in the illustration above. Raise
hinged front panel for zone-coverage
and hold-down function information.
Regular Functions
entering arm/disarm code(s) and for selecting
zones to be shunted (bypassed). Also have
special Hold-Down Functions as described in
Hold-Down Functions.
be shunted (bypassed). Also has a special
Hold-Down Function as described in Hold-
Down Functions.
CONTROLS & INDICATORS
6
immediate emergency when both buttons
pressed at the same time.
Red ARMED/MEMORY Light. Glows
steadily to indicate that the system is armed. A
flashing light when armed warns that the panel
was in an alarm condition. It can also indicate
which zones were violated (also see Hold-
Down Functions).
indicate that all zones are operating properly
and the system may be safely armed. A flash-
ing light warns which non-24-Hour Zone(s) are
in trouble. (To stop flashing, hold down Key
[3]. See Hold-Down Functions).
indicate that one or more zones have been
bypassed and that the system is only partially
armed. The light can flash to indicate which
zones have been bypassed (see Hold-Down
Functions, Key [S]).
tone whenever:
an attempt is made to arm the panel
l
when a zone is in trouble;
entry delay is in progress, to remind
l
the user to disarm;
a Day Zone is in trouble.
l
A momentary beep when arming indicates that
a zone is being auto-shunted.
are