NAPCO MAGNUM ALERT-725 Operating Manual page 11

Disarming When You Return
When you enter through the exit/entry door,
the Mini-Sounder will come on during the entry
period to remind you to disarm. Check the red
ARMED/MEMORY light; if it is flashing, an
alarm occurred while you were out.
Using your code, disarm the
WITH CAUTION!
system immediately during the entry period
both to prevent an alarm and to silence the
Mini-Sounder.
NOTE:
1. If you enter the wrong code, you must wait
at least 2 seconds before trying again. If there
was an extended power failure and your
system does not respond to your correct code,
enter your preprogrammed fallback code to
disarm. See page 9.
2. If your MAGNUM ALERT-725 is used as an
area arm module that is part of a larger
system, and an alarm occurred on your
premises, silence the alarm by disarming at
your
keypad.
To identify which zone(s) were violated, hold
down Alarm History Key [2] until a beep
sounds, but do not release it. The red ARMED/
MEMORY light will flash to indicate the last
alarm condition. Count the number of flashes
to determine which zone(s) require attention.
PROCEED
NOTE: If an alarm occurred and the red light
did not flash, a 24-Hour Zone (see your Alarm
Plan) was violated. The cause of the alarm
must be determined and cleared before you
can rearm your panel. Hold down Alarm
History Key [2] to display the zone(s) violated.
11