Sound Setting; Adjusting Subwoofer Level/Bass Level/Treble Level/Balance (Between Left And Right)/Fader (Between Front And Rear)/Defeat; Setting The Subwoofer Level; Setting The Bass Control - Alpine CDA-9884R Owner's Manual

Sound Setting

SOURCE/ Rotary encoder (AUDIO/LOUD)
/ENT
BAND/TA
/ESC
Adjusting Subwoofer Level/Bass Level/
Treble Level/Balance (Between Left and
Right)/Fader (Between Front and Rear)/
Defeat
1
Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBW LEVEL* BASS LEVEL
BALANCE FADER DEFEAT
Subwoofer level: 0 ~ +15
Bass level: –7 ~ +7
Treble level: –7 ~ +7
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
• If no operation is performed for 5 seconds after selecting the SUBW
LEVEL, BASS LEVEL, TREBLE LEVEL, BALANCE, FADER or
DEFEAT mode, the unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
Refer to "Turning Subwoofer ON/OFF" (page 17).
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of
BASS and TREBLE will return to the factory defaults.
Depending on the connected devices some functions and
display indications do not work.
SOUND SETUP
TREBLE LEVEL
VOLUME SUBW LEVEL

Setting the Subwoofer Level

You can change the Subwoofer Level to create your own tonal
preference.
1
Press SOUND SETUP to activate the Sound Setting
mode.
2
Turn the Rotary encoder to select the SUBW
LEVEL Adjustment mode, and then press
1
SUBW LEVEL* BASS*
BLACK OUT SUBW LEVEL
3
Turn the Rotary encoder to select the desired
subwoofer level (0~+15).
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
1
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
Refer to "Turning Subwoofer ON/OFF"(page 17). The adjustment
can also be made by pressing Rotary encoder (AUDIO). Refer to
"Adjusting Subwoofer Level/Bass Level/Treble Level/Balance
(Between Left and Right)/Fader (Between Front and Rear)/Defeat"
(page 15)
2
* The function is inoperable when DEFEAT is set to ON.

Setting the Bass Control

You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press SOUND SETUP to activate the Sound Setting
mode.
2
Turn the Rotary encoder to select the BASS
Adjustment mode, and then press
3
SUBW LEVEL* BASS*
BLACK OUT SUBW LEVEL

Setting the Bass Centre Frequency

3
-1 Press BAND/TA to select the desired bass centre
frequency.
80 Hz 100 Hz 200 Hz
Emphasises the displayed bass frequency ranges.

Setting the Bass Bandwidth

3
-2 Press SOURCE/ to select the desired bass
bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the centre frequency. A narrower setting will
boost only frequencies near the centre frequency.
/ENT.
2 2 2
TREBLE* HPF*
/ENT.
4 4 4
TREBLE* HPF*
60 Hz 80 Hz
15
-EN