Ca91 Stand Assembly Instructions - Kawai CA91 Owner's Manual

Page
80

CA91 stand assembly instructions

Thank you for purchasing a KAWAI Concert Artist digital piano.
First, read this instruction manual and make sure that all the parts are included, and assemble the unit while being careful not to scratch or damage the
stand. (Follow the procedures in reverse order when disassembling the unit.)
Parts (included items)
Side panel (left)
Stand
Assembly sequence
1. Remove the stand from the box.
(1) Insert the pedal support (E) about 1 cm into the bottom of the stand.
(2) Pull out the pedal cord and speaker cord, hang over the back of the
stand.
Pedal support insert hole
(back of the pedal stand)
2. Remove the piano from the box, and temporarily place it onto
the stand.
Place the piano onto the stand temporarily.
Important points:
· Place the piano in the manner that the dowels fi t in the holes provided
on the bottom surface of the piano.
· Place the piano on the stand in the manner that the piano part and
the stand will not be perfectly aligned; the piano part must be off by
approximately 3 cm towards the back.
Make sure that more than two people work on unit
Caution
assembly.
Make sure that your hands are not caught between
9
the piano and the stand when you place the piano
on top of the stand.
Use a Phillips-head screwdriver (+) to assemble the unit.
Score stand
Headphone hook
Piano
Headphone hook mounting
4 x 14 (x 2)
Side panel (right)
Pedal cord
Speaker cord
Piano
About 3 cm
Stand
Dowel
Back panel
(with a fl at end)
A. M4 x 35 (x 8)
L-shaped bracket (x 2)
B. M4 x 16 (x 6)
(with a sharp end)
C. 4 x 12 (x 2)
screw
Power cord
3. Connecting the cables.
While the piano is temporarily placed on the stand, connect the pedal cord
and speaker cord to the piano.
Connector
Locking tab
Speaker cord
Important points:
· Make sure that the locking tabs are facing the correct direction.
· Insert the connector straight.
Do not apply too much force; it may cause unit failure.
* To pull out the cord, remove the connector while pressing the locking
tab.
4. Correcting the piano position.
Using the rear most holes for the dowels, correct the piano position by
moving the piano forward on the stand 3 cm.
Dowel
Important points:
· When placing the piano on the stand, make sure the dowels fi t in the
holes provided on the bottom surface of the piano.
· When placing the piano on the stand, the piano and the stand will not
be perfectly aligned; the piano should be offset by approximately 3 cm
towards the back.
When correcting the piano position, do not pull the
Caution
pedal cord and speaker cord.
Assembling screws
[Others]
D. Cord clamp (x 2)
E. Adjuster (x 1)
Make sure that more than two
Caution
people work on unit assembly.
Connector
Locking tab
Pedal cord