Quiet Mode; Programming And Consulting The Schedule Timer - Daikin EKHVMRD50AAV1 Operation Manual

Quiet mode

Refer to "Programming quiet mode" on page
Switch the mode on or off at a scheduled time. 4 actions can be
programmed per mode. These actions are repeated daily.
■
NOTE If the auto restart function is disabled, the
schedule timer will not be activated when power
returns to the unit after a power supply failure.
Press the pr button to enable the schedule timer
again.
■
When power returns after a power supply failure,
the auto restart function reapplies the user
interface settings at the time of the power supply
failure (if time is shorter than 2 hours). It is
therefore recommended to leave the auto restart
function enabled.
■
The programmed schedule is time driven.
Therefore, it is essential to set the clock and the
day of the week correctly.
Refer to "4.2. Setting the clock" on page
■
When the schedule timer is not enabled (p icon
not displayed), schedule timer actions will not be
executed!
■
The programmed actions are not stored according
to their timing but according to the time of
programming. This means that the action that was
programmed first gets action number 1, even
though it is executed after other programmed
action numbers.

4.12. Programming and consulting the schedule timer

Programming the schedule timer is flexible (you can add, remove or
alter programmed actions whenever required) and straightforward
(programming steps are limited to a minimum). However, before
programming the schedule timer, remind:
■
Familiarize yourself with the icons and the buttons. You will need
them when programming. Refer to
buttons and icons" on page
■
Fill out the form at the very end of this manual. This form can
help you define the required actions for each day.
■
Take your time to enter all data accurately.
■
Try to program the actions in a chronological way: start with
action 1 for the first action and end with the highest number for
the last action. This is not a requirement but will simplify the
interpretation of the program later.
■
If 2 or more actions are programmed for the same day and at the
same time, only the action with the highest action number will be
executed.
Example:
Programmed actions
Time Temperature
(hour) (°C)
1 18:00 — OFF
2 08:00 —
3 06:00 —
4 18:00 —
■
You can always alter, add or remove the programmed actions
later.
Operation manual
13
17.
5.
"4.1. Remote controller
3.
Executed actions
Time Temperature
(hour)
1 06:00 —
23 2 08:00 —
21 3 18:00 —
26
(°C)
21
23
OFF
EKHVMRD50+80AAV1 + EKHVMYD50+80AAV1
Daikin Altherma indoor unit
4PW61264-1A – 10.2010