Midway Fence - SafetySpeed Panel Saw and Router Owner's Manual

SR-5, 7400, and 7400XL, and is not available for the Model TR-2.
Installation
NOTE: All hex nuts furnished with this accessory are lock nuts. During preassembly, do not completely tighten
these nuts.
1. Lay out the parts shown in Figure 44 on a horizontal surface (table or bench) for preassembly. Note that one
end of each fence extrusion is cut at a 45° angle. The units should be preassembled so that these beveled
ends will fit against the center of the tool frame at final assembly.
2. Set the complete right-hand fence assembly onto the tool frame as shown in Figure 45.
3. Tip the top of the rear support brackets (#9 in Figure 44) under the upper horizontal frame member (#8),
raise the fence, and push the lower ends of the rear support brackets down behind the lower horizontal
frame member. The nuts may have to be loosened slightly to perform this step.
4. Tap the entire fence system toward the center of the tool frame, and align (as closely as possible) the 45°
angle of the aluminum extrusion (#5) with the 45° angle of the vertical tube at the center of the frame. To
assure a neat appearance, be sure the rear support brackets (#9) are flush top and bottom with the machine
frame tubes, and that they are at a 90° angle to the horizontal machine frame tubes.
5. Double-check the position of the complete fence assembly. Using the holes in the rear support brackets as a
template, drill six 7/16" mounting holes in the machine horizontal frame tubes, and secure with six self-
Figure 44: Preassembly of Midway Fence
LEFT SIDE
Figure 45: Mounting the Midway Fence
40
RIGHT SIDE