Midway Fence - SafetySpeed 6400 Owner's Manual

Panel saw c-series, h-series
Hide thumbs Also See for 6400:
Table of Contents

Advertisement

5. Attach the brackets to the frame, using four ¼-20 (6.35mm) self-tapping hex-head screws.
6. Measure from the blade and adjust the Quick Stop measuring tape by sliding it in the angle extrusion.
Operation
1. Position the stop block at the desired cut length, as shown by the Quick Stop measuring tape, and secure the
block with the lock knob.
2. Raise the carriage to the top of the guides.
3. Slide the work piece behind the carriage, and hold it firmly against the stop block.
4. Cut the work piece with a smooth, continuous down stroke of the carriage.
The Midway Fence Accessory is a removable horizontal work piece support that mounts halfway up the tool frame.
It allows narrow work pieces to be worked at waist height. The fence consists of left and right fixed brackets that
mount to the frame, and removable supports for each side. The accessory contains the components shown in Fig.
57)
Installation
Unplug tool before making adjustments or installing accessories
NOTE: All hex nuts furnished with this accessory are lock nuts. During pre-assembly, do not completely tighten
these nuts.
Never reach behind the carriage!
Figure 56: Quick Stop installed

Midway Fence

50

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

6800

Table of Contents