SafetySpeed Panel Saw and Router Owner's Manual page 13

WARNING: To reduce the risk of injury, do not operate the tool without the blade guard
in place.
Installing the Blade Guard (Saws)
NOTE: The Models 7400 and 7400XL do not have a separate blade guard.
The blade guard (Figure 8 or Figure 9) is in the box marked "Saw Motor." Always install the blade guard before
operating the saw. The guard is shipped with two or three red torque knobs (22) installed, depending on the
model. Remove the knobs to install the guard. Be sure to leave the rubber washers on the torque knobs,
because they prevent the knobs from slipping.
Attach the guard to the carriage by reinstalling the torque knobs as shown (21).
Return the carriage to the top of the guide tubes and tighten the carriage lock.
Installing a Bit (Routers)
1. Disconnect power to the unit.
2. Lock the carriage lock.
3. Loosen the wing nut on the router base.
4. Rotate the motor counterclockwise, and remove it.
5. Using the wrench kit provided, loosen the collet and remove the bit.
6. Install the new bit and tighten the collet securely.
Adjusting the Crosscut Rulers (Saws)
The saw has one rip ruler mounted vertically, and two crosscut rulers, one attached to the frame on each side of
Figure 8: Installing the Blade Guard (Models C-4, H-4, H-5, H-6)
Torque
Knobs
Figure 9: Installing the Blade Guard (Models 6400, 6800)
13