Mantel And Wall Projections; Facing Material - Heat & Glo Escape-42DV Owner's Manual
Natural gas
Hide thumbs
Also See for Escape-42DV:
- Owner's manual (64 pages) ,
- Brochure & specs (4 pages) ,
- Owner's manual (57 pages)
Table of Contents
Advertisement
B. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specifi ed. Framing closer than the minimums list-
ed must be constructed entirely of noncombustible materials
(i.e., steel studs, concrete board, etc.)
Combustible Mantels
39 IN.
11-12 IN.
NON-COMBUSTIBLE
FACING MATERIAL
MIN. 1/2 IN. THICKNESS
Height
in.
6
7
above
mm 152 178
opening
Horizontal
in.
3
4-3/4
Mantel
mm
76
121
distance
Figure 13.4 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles
3-1/2 IN.
FINISH WALL
COMBUSTIBLE
NO COMBUSTIBLES
IN THIS AREA
COMBUSTIBLE
FRAMING
METAL PANELS
(PROVIDED)
COMBUSTIBLE
PROJECTIONS
12 IN.
10-1/2 IN.
9 IN.
7-1/2 IN.
6 IN.
4-3/4 IN.
12 IN.
3 IN.
MIN.
8 IN. MIN.
6 IN. MIN.
TOP OF FIREPLACE
OPENING
8
9
10
11
12
203
228
254
279
305
6
7-1/2
9
10-1/2
12
152
191
228
267
305
Heat & Glo • Escape-42DV • 2052-900 Rev. X • 3/11
Combustible Mantel Legs or Wall Projections
4 INCH
MINIMUM
NON-COMBUSTIBLE
MATERIAL
Figure 13.5 Combustible Mantel Leg or Wall Projections
(Acceptable on both sides of opening)
C. Facing Material
• The appliance front metal surfaces may be covered with
non-combustible materials only.
• Non-combustible materials MUST be placed around the
fi replace opening (see Figure 13.6)
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers and door
or removal of the right, left and bottom refractory panel
for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
• Seal joints between the fi nished wall and appliance top
and sides using a 300 °F minimum sealant. Refer to
Figure 13.7.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of doors and louvers.
UNLIMITED
45
Advertisement
Table of Contents
