Network; Connection Via Network Cable - Dreambox DM7020 HD User Manual

Standby
1. With the Navigation-Buttons (
2. With the Navigation-Buttons (

6.6 Network

6.6.1 Connection via network cable

Adapter-Settings
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons (
3. With the Navigation-Buttons (
4. With the Navigation-Buttons (
5. With the Navigation-Buttons (
Button.
6. Use the Navigation-Buttons and the Numeric-Keypad to change the settings.
Use interface This option toggles the integrated ethernet interface on and off.
Use DHCP If enabled your Dreambox will get its IP from a DHCP server. If you are using a router to
access the internet you usually have a DHCP server. Disable this option to set a static IP address.
Manually setting an IP address
These settings are only needed if you have selected "no" on the "Use DHCP" option before
IP-Address Enter the IP address here.
Free IP-Addresses: 192.168.0.2 - 192.168.0.254
Netmask Enter the subnet mask (Usually 255.255.255.0).
Gateway Enter the router's IP address here, if the Dreambox is connected to the Internet over a router.
Usually this is: 192.168.0.1
To save the settings and activate the network connection press the OK-Button.
DNS-Settings
Note: If you have set the "Use DHCP" option to "yes" you won't have to enter anything here since
this will be done automatically.
Nameserver Enter the DNS-Server's IP address here. DNS is used to translate a Domain name to an IP
address. Normally, if the Type is set to LAN, there is no need for a DNS entry. If the Dreambox
is connected to the Internet over a router, enter the router's IP address here. Press the green
Options-Button if you want to add a second nameserver and the yellow Options-Button to
delete a nameserver. You can enter a maximum of two nameservers.
) choose the option "Standby".
) choose the brightness of the OLED-Display for standby mode.
) choose the option "Setup" and press the OK-Button.
) choose the option "System" and press the OK-Button.
) choose the option "Network" and press the OK-Button.
) choose the option "Adapter Settings" and press the OK-
52