Replacing Fixed Glass Assembly; Air Shutter Setting; Install Control Heat Shield - Heatilator NEVO4236I Owner's Manual

H. Replacing Fixed Glass Assembly
• Set the glass panel on the lower two or four glass
assembly latches, ensuring the glass panel is centered
in the opening.
• Replace glass latches. See Figure 15.2.
I. Air Shutter Setting
Air shutter setting should be adjusted by a qualifi ed in-
staller at the time of installation.
• The air shutter is set at the factory for minimum vertical
vent run.
• Adjust air shutter for longer vertical runs. See
Figure 15.7.
• Turn the thumbscrew to open and close.
Close
Figure 15.7 Adjusting Air Shutter
J. Install Control Heat Shield
The control heat shield is shipped in the bottom of the ap-
pliance and MUST be placed over the control plate before
operating the appliance. Failure to place the control heat
shield may result in overheating the controls on the plate.
• Locate control heat shield and remove from appliance.
Control Heat Shield
Figure 15.8 Locate Control Heat Shield
58
Open
Heatilator • Evolution • 4065-114 • Rev H • 7/10
• Bend four legs at 90° angle as shown in Figure 15.9.
Bend to a 90° angle
Figure 15.9 Bend Control Heat Shield Legs
• Place control heat shield over control plate so that all of
the control plate is covered and legs are on bottom pan
of appliance.
Control Heat Shield in Place
Figure 15.10 Control Heat Shield - Installed
• Make sure all wires are under the top of the control heat
shield and that there are no wires pinched between legs
and the bottom pan.