Soleus Air HM1-10-32 Owner's Manual page 7

3. Leave the thermostat control at its maximum setting until the desired temperature is
reached. Carefully lower the thermostat control by turning counter-clockwise until the
heater stops operating. The indicator light will shut off.
4. Leave thermostat control at this position. The heater will automatically cycle on and off
to maintain the chosen room temperature. The indicator lights will also turn and off to
indicate when the heater is operating.
5. Unplug the heater when not in use.
NOTE: For safety, if the heater's internal temperature rises above a certain point, the heater
is designed to automatically shut off. To restart the heater in this situation:
1. Turn the POWER SELECT dial to OFF, and set the thermostat control to LOW.
2. Unplug the power cord from the outlet and allow the heater to cool for at least 10
minutes.
3. Plug the power cord back into the outlet and select the desired heat setting.
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit
between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting
the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for
damage.
7