Routing - TC-Helicon VOICEPRISM PLUS User's Manual Supplement

VoicePrism Plus User Manual

ROUTING

ROUTING
audio processing and path..
DIGITAL SOURCE
S/PDIF jacks, or
48V
the
The
MIC ON
back of the unit.
AUX INPUT
right channels of the card, or from the auxiliary input jack on
the back panel. These inputs are then sent to the effects sec-
tion of the VoiceCraft card. To avoid digital signal conflicts,
you are prevented from selecting the same
as the digital
PROCESS DELAY
tain amount of time is required to analyze and modify the
output signal. The VoicePrism Plus requires 20 ms of time for
optimal performance. Increasing
VoicePrism Plus to do a more concentrated signal analysis for
greater accuracy. As some vocalists in a live situation may
feel uncomfortable about hearing a delay, you can reduce
the amount of processing time, being aware that the quality
of the modeled voice is reduced at lower settings.
is a new menu, with four parameters to control
: may be set to
/
AES EBU
jacks on the back of the expansion card.
LEAD INPUT
back panel, or the Mic preamp on the front
of your VoicePrism Plus, set the
to
ANALOG
MIC ON
button if you require phantom power for your mic.
button must be
: you can now accept a digital input from the left or
LEAD INPUT
: whenever Voice Modeling is activated, a cer-
for a digital signal on the
,
SPDIF
to select input from the AES/EBU
: to use your analog line in on the
. To use the microphone input, the
button must be selected, as well as
to use
OFF
channel.
PROCESS DELAY
% 21 %
Utility Button
LEAD INPUT
input from the
LINE
channel
AUX INPUT
enables the