Reset To Factory Default Settings - Axis Q6045–S User Manual

Ptz dome network camera

Hide thumbs Also See for Q6045–S:

Table of Contents

AXIS Q6045–S PTZ Dome Network Camera

System Options

Reset to Factory Default Settings

Important

Reset to factory default should be used with caution. A reset to factory default will reset all settings, including the IP

address, to the factory default values.

Note

The installation and management software tools are available on the CD supplied with the product and from the support

pages on www.axis.com/techsup

To reset the product to the factory default settings:

1. Disconnect power from the product.

2. Press and hold the control button and reconnect power. See Hardware Overview, on page 6 .

3. Keep the control button pressed for about 15–30 seconds until the status LED indicator flashes amber.

4. Release the control button. The process is complete when the status LED indicator turns green. The product has been reset

to the factory default settings. If no DHCP server is available on the network, the default IP address is 192.168.0.90

5. Using the installation and management software tools, assign an IP address, set the password, and access the video stream.

It is also possible to reset parameters to factory default via the web interface. Go to Setup > System Options > Maintenance.

Table of Contents