Getting Started; Setting Up Your Thin Computer; Step 1 - Install The Battery; Step 2 - Connect The Power Cable - Wyse X90L User Manual

3

Getting Started

This section provides information on setting up and using your thin computer, power
management, and the graphics system.

Setting Up Your Thin Computer

To quickly set up your thin computer follow the next three simple steps.

Step 1 - Install the Battery

With your thin computer turned off, insert battery in the battery compartment located on
the underside of the thin computer and secure it by sliding the latches.
1. Slide the battery lock (3) to unlock.
2. Slide and hold the battery release latch (1) as you gently insert the battery (2) into the
3. Make sure that the battery lock (3) locks back into position.
Figure 3-1 Battery Latches

Step 2 - Connect the Power Cable

Plug the power adapter connector to the thin computer as shown. Plug the AC power
cable to the power adapter, and then plug the other end of the power cable to a wall outlet.
battery compartment. Make sure the battery is properly orientated.