Using Hp 3D Driveguard Software; Using Optical Drives (Select Models Only); Identifying The Installed Optical Drive; Inserting An Optical Disc - HP Notebook User Manual

Using HP 3D DriveGuard software

The HP 3D DriveGuard software enables you to perform the following tasks:
●
Enable and disable HP 3D DriveGuard.
NOTE:
DriveGuard. Privileges for non-administrator users can be changed by members of an
administrator group.
●
Determine whether a drive in the system is supported.
To open the software and change settings, follow these steps:
1. Double-click the icon in the notification area, at the far right of the taskbar.
– or –
Right-click the icon in the notification area, and then select Settings.
2. Click the appropriate button to change settings.
3. Click OK.

Using optical drives (select models only)

Optical drives include the following:
●
CD
●
DVD
●
Blu-ray (BD)

Identifying the installed optical drive

From the Start screen, type windows, click Windows Explorer, and select Computer.
▲
A list of all the devices installed in your computer, including your optical drive, is displayed.

Inserting an optical disc

Tray-load

1. Turn on the computer.
2. Press the release button (1) on the drive bezel to release the disc tray.
3. Pull out the tray (2).
4. Hold the disc by the edges to avoid touching the flat surfaces and position the disc label-side up
over the tray spindle.
NOTE:
Depending on your user privileges, you may be unable to enable or disable HP 3D
If the tray is not fully accessible, tilt the disc carefully to position it over the spindle.
Using optical drives (select models only) 65