EnGenius FreeStyl 1 User Manual page 9

Allow changing the handset password which requires to enter in Call
Barring (MENU-4-4) and Menu Display (MENU-8) .
Re:Default is "0000".
23. Change PIN
Allow changing the Base PIN which requires to enter in Base Settings
(MENU-6).
Re: Default is "0000".
24. DTMF Duration
a. From MENU-6-1 to select variable duration of DTMF tone.
b. Default is 100ms.
c. When entering the base setting, PIN is required. Default is "0000".
Re: Better to check with your phone company first before changing it.
25. Programmable Flash key timing
a. From MENU-6-2 to select flash key timing
b. 9-level (100 ms - 900 ms) timing selections, default= 600 ms.
c. The default value (600 ms) works in most areas. Changing this
setting may cause Flash key to stop working. Change only when
you are certain the new value will work.
d. When entering the base setting, PIN is required. Default is "0000".
26. Assign handset ID for new handset
a. Using registered handset from MENU-6-3 to assign a handset ID to
a new handset.
b. If not assigned handset ID, the system will automatically assign a
handset ID to a new handset.
c. When entering the base setting, PIN is required. Default is "0000".
27. Clear Handset
a. Use registered handset from MENU-6-4 to remove the other
registered handset, in case the other registered handset is defective.
b. Once the other registered handset is cleared, the user is able to
register a new handset for instead.
c. When entering the base setting, PIN is required. Default is "0000".
28. Change PIN
Allow changing the base PIN which requires entering the "Base Settings"
(MENU-6-5).
a. Use registered handset to change PIN from MENU-6-5.
b. Default PIN is "0000".
c. When entering the base setting, PIN is required. Default is "0000".
~17~
29. Auto Hang Up feature
a. Using registered handset from MENU-6-6 to turn on/off the Auto
hang up feature.
b. If turning on the feature, the handset will automatically hang up the
call when the other-end hangs up the call.
c. When entering the base setting, PIN is required. Default is "0000".
30. Set Time
The set time function allows user to set date/time to support the DTMF
caller ID (DTMF caller ID doesn't attach date/time when receiving from
PSTN, using this setting, user is able to review the date/time when the
caller ID is received).
a. Enter MENU-6 to set Base Settings.
b. Enter Base PIN (Default is "0000").
c. Enter "7" to enter Set Time.
d. Enter 4 digits for MM/DD(Month/Day), then enter 4 digits for hr:mm
(Hour：Minute)
e. Press SAVE (left soft key) to finish the setting.
~18~