Dmx Linking; Dmx Modes; Master/Slave Linking - Chauvet Q-SPOT 260 LED User Manual

Setup
You may link the Q-Spot 260-LED to a DMX controller using a standard DMX serial

DMX Linking

connection. If using other DMX compatible fixtures with the Q-Spot 260-LED, it is
possible to control them individually with a single DMX controller.
It is also possible to run several DMX compatible fixtures synchronized without a DMX
controller in a master/slave operating mode.
If you are not familiar with the DMX standard, please refer to the DMX Primer and DMX
Connectivity sections in the Appendix chapter of this manual.

DMX Modes

The Q-Spot 260-LED uses the standard DMX data connection for its DMX modes,
Advanced and Basic. Refer to the Operation Instructions chapter to learn how to
configure the Q-Spot 260-LED to work in these modes. The DMX Values section will
give you detailed information regarding the above-mentioned DMX modes.
The Master/Slave mode allows a Q-Spot 260-LED fixture (the master) running a
Master/Slave
preconfigured program to control several other Q-Spot 260-LED fixtures (the slaves)
Linking
without requiring a DMX controller. In this mode, all the slave fixtures will operate in
unison with the master fixture.
When in Master/Slave mode, the Q-Spot 260-LED units link to each other using the
standard DMX connection.
If you are not familiar with the Master/Slave connectivity, please refer to the DMX
Primer and DMX Connectivity sections in the Appendix chapter of this manual.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
April 7, 2010 -7- Q-Spot 260-LED User Manual Rev. 01d