Charging Times - Vector VEC1087 A Owner's Manual & Warranty Information

Smart automatic battery charger 12 volt 2/6/10 amp charge rates
Table of Contents

Advertisement

APPENDIXA - CHARGING TIMES
To calculate the approximate charging time required to fully charge a battery, it is necessary to determine the specific
gravity (or, percent of battery charge) using a hydrometer. Use this technique if battery vent caps can be removed. Check
each cell. A cell with a very low specific gravity compared to the other cells probably means a shorted cell in the battery.
Replace the battery.
The following chart converts hydrometer readings into percent of charge values.
SPECIFIC GRAVITY
(HYDROMETER READING)
1.265
1.225
1.190
1.155
1.120
Refer to the chart below for approximate charging times.
PERCENT OF CHARGE
2 AMPS
6 AMPS
10 AMPS
* Not recommended.
The times shown in the chart above are approximate and refer to an average automotive battery. For smaller batteries,
the charge time should be adjusted using the formula shown below and adding 1 hour to the time calculated. To estimate
charging time for a discharged battery, divide the amp hour (AH) rating of the battery by the charge rate selected. This
is the number of hours required to recharge the battery. For example, a 50 Ah (12 volt) battery is discharged (10 volts).
How long should it be charged at the 6 Amp rate? Divide the 50 Ah by 6.
Answer: approximately 8 hours. Always round up charge time by 10% to ensure full charge. In most cases, battery charge
times will vary depending on age and condition of battery. Smaller batteries should be charged at the lower rate (2 Amps)
and add an extra hour to charge time.
PERCENT OF CHARGE
IN BATTERY
100%
75%
50%
25%
0%
75%
50%
7 HRS
13 HRS
2.5 HRS
5 HRS
1.5 HRS
3 HRS
9
PERCENT OF CHARGE NEEDED
BY BATTERY
0%
25%
50%
75%
100%
25%
0%
NR*
NR*
7 HRS
9 HRS
4 HRS
5 HRS
VEC1087 A
REV101103

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents