CEL 10.8v Li-ion User Manual page 15

Operating
Sanding
The removal rate and the sanding
pattern are primarily determined by
the choice of sanding sheet, the
preset oscillation rate and the
applied pressure.
Flawless sanding sheets achieve the
best sanding capacity and extend the
service life of the machine.
Try to apply uniform sanding
pressure; this increases the working
life of the sanding sheets.
Additional pressure does not lead to
an increased sanding capacity, only
increased wear of the machine and
the sanding sheet.
For precise on-the-spot sanding of
edges, corners and hard to reach
areas, it is also possible to work only
with the tip or an edge of the sanding
plate.
When selectively sanding on the
spot, the sanding sheet can heat up
considerably. Reduce the oscillation
rate and allow the sanding sheet to
cool down regularly.
A sanding sheet that has been used
for metal should not be used for
other materials.
Use only original CEL sanding
accessories.
Scraping
For scraping, select a high oscillation
rate. Work on a soft surface (e.g.
wood) at a flat angle, and apply only
light pressure. Otherwise the scraper
can cut into the surface.
Sharp blades, heat buildup and
flying debris are a danger to user
and bystanders. Use of suitable
protective clothing, gloves,
footwear, eye and ear protection
as well as safe working practices
can reduce these risks.
9.0