Specifications; Q-See Product Warranty; Questions Or Comments? Contact Us; Pelco-P - Q-See QD6531Z User Manual

SPECIFICATIONS

Specification QD6531Z
Image Sensor 1/3" Sony Exview HAD CCD-II
Digital Signal Processor Sony Effio-E
Signal System NTSC or PAL models
Lens 2.1 Megapixel 5-15mm F2.2
2.0MP auto focus lens
Scanning 2:1 Interlace
Sync. System Internal
Horizontal System 650TVL
Effective Pixels (HxV) NTSC:976x494 PAL:976x582
Shutter Speed NTSC=1/60 ~1/100,000 sec
PAL=1/50 ~1/100,000 sec.
Minimum 0 Lux with IR LEDs on
Illumination
IR LEDs 4x Super LEDs, 8x chip-mounted LEDs
IR Range 80'
S/N Ratio > 52dB
Gamma 0.45
White Balance Auto
BLC Auto
AGC Auto
Video Output 1.0V P-P,75Ω BNC
Input Current 12V 1200mA
Operating Temp 14°F to 122°F (-10°C to 50°)
(relative humidity: up to 95%)
Power <8W
Consumption
Protection IP66
Rating
Operating Temp 14°F to 122°F (10°C to 50°C)
Storage Temp -22°F to 158°F (-30°C to 70°C)
Color Dark Gray
Address Range 1-64
Control Protocol Pelco-D and Pelco-P
Baud Rate 1200b/2400b/4800b/9600b
16
QD6505P
2.1 Megapixel 6mm lens
Beige
Q-SEE PRODUCT WARRANTY
Q-See is proud to back all of our products with a conditional service warranty covering all
hardware for 12 months from the date of purchase. Additionally, our products also come with
a free exchange policy that covers all manufacturing defects for one month from the date of
purchase. Permanent upgrading service is provided for the software.
Liability Exclusions:
Any product malfunction or abnormalities in operation or damage caused by the following
reasons are not within the free service scope of our company:
1. Equipment damage caused by improper operation.
2. Improper equipment operation environment and conditions (e.g., improper power,
extreme environmental temperatures, humidity, lightning and sudden surges of
electricity).
3. Damage caused by acts of nature (e.g., earthquake, fire, etc).
4. Equipment damage caused by the maintenance of personnel not authorized by Q-See.
5. Product sold over 12 months ago.
In order to fulfill the terms of your warranty, you must complete the registration process after
purchasing our product. To do this, simply fill out the User's Information Card on our website
at www.Q-See.com
QUESTIONS OR COMMENTS? CONTACT US
24/7 TECHNICAL RESOURCES,
KNOWLEDGE BASE AND MORE
www.Q-See.com/Support
17