Operating The Refrigerator Controls (N62X, N62Xxx, N82X, And N82Xxx Models); Control Panel; Automatic Mode Operation; Removing Air From The Propane Gas Supply Lines - Norcold N62X Owner's Manual

NOTE: If you open the door(s) too often, the temperatures
inside the freezer and fresh food compartment
do not become stable. Allow the refrigerator to
operate for about one hour after each adjustment
change before you examine the contents. The
number "9" is the coldest temperature setting.
- If the temperature is too warm, push and hold the
TEMP SET button to raise the temperature setting
by one number.
- If the temperature is too cold, push and hold the
TEMP SET button to lower the temperature setting
by one number.
- Have the refrigerator serviced by your dealer or a Norcold
authorized Service Center as soon as possible.
Operating the Refrigerator Controls
(N62X, N62XXX, N82X, and N82XXX
models)

Control panel:

1-COLD
Art01019
33
The refrigerator control panel (see Art01019) is between the
freezer compartment and the fresh food compartment. A 12 volt
DC power supply is necessary for the control functions of the
refrigerator to operate. The refrigerator receives DC power from
the 12 volt system of the vehicle; either an auxiliary battery, a
converter, or the vehicle engine battery.
The ON / OFF button [30] starts and shuts down the refrigerator:
- To turn on the refrigerator, push and release the ON / OFF
button.
- To turn off the refrigerator, push the ON / OFF button for one
second and then release.
The TEMP SET button [32] controls the temperature adjustment
of the freezer and the fresh food compartment. The temperature
adjustment that you select does not change if the mode of
operation of the refrigerator changes.
35
36
AC LP GAS TEMP
MODE
SET
AUTO
COLDEST-9
34 32
- Push the TEMP SET button and the temperature setting "1-9"
appears in the center display [33].
- Push and hold the TEMP SET button and the temperature
setting changes.
- When the desired temperature setting shows, release
- The temperature setting shows for ten seconds and then
- The number "9" is the coldest temperature setting.
The MODE button [31] controls the operation mode of the
refrigerator.
- Push and hold the MODE button and a light bar shows in the
center display beside each of the operating modes of the
refrigerator, one at a time.
- There is one automatic mode of operation and two
- When the light bar shows beside the mode of operation

Automatic mode operation:

When the refrigerator is in AUTO mode, it automatically uses
the most efficient energy source that is available for operation.
During operation, if a more efficient energy source becomes
available, the refrigerator controls change from the current
energy source to the more efficient energy source as follows:
ON
OFF
- The first choice is AC operation if 120 volts AC is available to
the refrigerator.
- The second choice is propane gas operation if 120 volts AC
is not available to the refrigerator.
31
30

Removing air from the propane gas supply lines:

For safety reasons, the burner is made to ignite on propane gas
within a specified amount of time. When starting the refrigerator
for the first time, after storage, or after replacing propane gas
tank, the propane gas supply lines can have air in them. Due
to the air in the gas supply lines, the burner may not ignite on
propane gas within the specified amount of time.
To remove the air from the propane gas supply lines:
- Make sure that all of the gas valves are open.
- Push the ON / OFF button to turn the refrigerator on.
the TEMP SET button.
the current operation mode of the refrigerator shows.
manual modes of operation.
that you choose, release the MODE button to operate
the refrigerator in that mode.
Owner's Manual 5