Quick Reference Digital Single Channel Recorder EDSR400h Quick Reference...
Page 2
Notice: The information in this Quick reference was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. Make sure the HDD is locked in with the keys. Network Settings Connected Directly to a High Speed Modem 1.
Page 3
6. Enter the Gateway Address assigned to your network. This can be achieved using the Arrow buttons. 7. Exit the Menu by pressing the Menu button and Reboot the EDSR400 by powering it down and back up. (NOTE: Please be sure that ports 80, 1111, 2222, 3333, 4444, 6666 are open.) Dynamic IP Often times Dynamic IP addresses can cause conflicts when trying to connect to DVR(s) on a high speed internet connection.
Page 4
5. Turn on the camera(s) that you want to record on motion by setting the OP option ON next to the target camera. You should also set the sensitivity level for the target camera as well. Exit the Motion menu when finished. 6.