Table of Contents
Advertisement
The seat height and angle can also be adjusted using
the rear holding plate.
•
Loosen the rear fixing bolt on one side (in threaded
bush 1) so that the holding plate can be swivelled
upwards or downwards.
•
Under the front fixing bolts and take them out
(depending on the position, the bolt is either in
threaded bush 2 or 3).
•
Repeat the procedure on the other side.
•
Low setting = hole combination 1 and 2.
•
High setting = hole combination 1 and 3.
•
Apply a screw blocker system to the bolt,
reposition the bolt and tighten it to 25 Nm +/- 3 Nm.
44
Advertisement
Table of Contents
