Table of Contents
Advertisement
•
The picture on the right shows the position of
the perforated plates (1) and the holding plate
fixing screws (2) for adjusting the seat height
and seat angle.
The picture on the right shows the front perforated
plates. The procedure is similar for the rear
perforated plates. A 13 mm jaw spanner is
required in addition to a 5 mm Allen key for
adjusting the front perforated plates.
•
To adjust the seat height/seat angle, unto the
bolt (1) with the open-ended spanner and
remove it.
•
Adjust the perforated plate to the required
height/angle.
•
Apply a screw blocker system to the bolt,
insert the bolt again and tighten it to 40 Nm
with the open-ended spanner.
43
Advertisement
Table of Contents
