Operating The Homelink Wireless Control System; Erasing Homelink Buttons; Reprogramming A Single Homelink Button - Ford F150 Owner's Manual

Driver Controls
• Continue to press and hold the HomeLink button (note step 3 in the
"Programming" section) while you press and release — every two
seconds ("cycle") your hand-held transmitter until the frequency
signal has been accepted by the HomeLink . The indicator light will
flash slowly and then rapidly after HomeLink accepts the radio
frequency signal.
• Proceed with step 4 in the "Programming" section.

Operating the HomeLink Wireless Control System

To operate, simply press and release
the appropriate HomeLink button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink at www.homelink.com or
1–800–355–3515.

Erasing HomeLink buttons

To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink is now in the train (or
learning) mode and can be programmed at any time beginning with step
2 in the "Programming" section.

Reprogramming a single HomeLink button

To program a device to HomeLink using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release the
button.
70
2004 F150 (f12)
Owners Guide (post-2002-fmt)
USA English (fus)