Flat Surface Installation - Cisco SG 100D-08 Quick Start Manual

Insert a screw into each hole, leaving a gap between the surface
S 3
TEP
and the base of the screw head of at least 0. 1 inches (3 mm).
Place the unmanaged switch wall-mount slots over the screws and
S 4
TEP
slide the unmanaged switch down until the screws fit snugly into
the wall-mount slots.
Connect the unmanaged switch to the other devices, as described
S 5
TEP
in the "Connecting the Equipment"

Flat Surface Installation

To deploy the device on a desktop or other flat surface:
Place the unmanaged switch on a desktop near an AC power
S 1
TEP
source.
Connect the unmanaged switch to the other devices, as described
S 2
TEP
in the "Connecting the Equipment"
Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide
section.
section.
6