Celestron 47003 Instruction Manual

Personal Weather Station with
Wireless Remote Sensor
Model # 47003
Thank you for purchasing this Celestron personal
weather station. Please read the instructions prior to
using it and we hope you will have many years of
pleasure with it.
Insert the base to the bottom of the Receiver by
pushing it in until it clicks. The correct position is
shown in the image to the right
Set Up Power for the Receiver
For optimum performance, please place the Receiver away from metal and
other sources of interference such as mobile phones, TVs, computers,
appliances, etc. If the Receiver stops showing the display or dims, replace
the batteries.
Set Up the Power & Make Settings for the Wireless Remote Sensor
Remove the screw (center area of center image) from the rear door of the sensor with a small
screwdriver. Insert two AAA batteries (user supplied) as indicated in the sensor (see right image).
Set the switch to "1" (for Channel 1) - or if no switch is seen then nothing to do, push/toggle the
button so readings will be shown in "C" (Centigrade) or "F" (Fahrenheit). Then push the button
"TX" and hold it a couple of seconds to transmit the RF signal from the Sensor to the Receiver. The
Sensor itself will display the outside temperature (see left image). Replace the rear door of the sensor
by installing the screw to hold it in place.
The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to
communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely
(hanger part on left of center image) to any surface that is secure or it can stand by itself (if in an area
without wind, etc.).
.
Open the battery compartment door on the rear of the Receiver.
Then insert two AAA batteries (user supplied) with polarity as
indicated in the battery compartment. After installation, put the
battery compartment door back on.