Celestron 47007 User Manual

English
L F LCD
arge ormat
P W
ersonaL eather
s W
tation With ireLess
r s
emote ensor
m # 47007
oDeL
P r
oWering the eCeiver
Remove the protective film on the LCD. Open the battery compartment
door on the rear of the Receiver. Then insert two "C" batteries (user
supplied) with polarity as indicated in the battery compartment. After
installation, reattach the battery compartment door.
For optimum performance, please place the Receiver away from
metal and other sources of interference such as mobile phones, TVs,
computers, appliances, etc. If the Receiver stops showing the display or
dims, replace the batteries.
P a
oWering anD Djusting
Remove the protective film on the LCD. Remove the
small screw (center area of center image) from the
rear door of the sensor with a small screwdriver. Insert
two AAA batteries (user supplied) as indicated in the
sensor (see right image). Push/toggle the button so
readings will be shown in "C" (Centigrade) or "F"
(Fahrenheit). Then push the button "TX" and hold it
a couple of seconds which will transmit the RF signal
from the sensor to the Receiver. The Sensor itself will
display the outside temperature and humidity (see
left image). Replace the rear door of the sensor by
installing the small screw to hold it in place.
The Sensor can be mounted up to 100 feet (30
meters) in an open area from the Receiver to
s W
ettings For the
t
hank you For PurChasing this
C
eLestron PersonaL Weather station
P
Lease reaD the instruCtions Prior
to use
years oF enjoyment
r s
ireLess emote ensor
communicate with it. The Sensor has a place on the
rear of the unit to mount/hang it securely (hanger part
on left of center image) to any surface that is secure
or it can stand up (if in an area without wind, etc.)
by folding out the small stand (right part of center
image).
If the battery power becomes low, a "low battery
icon" will appear on the LCD display and change
batteries to ensure a strong signal is being sent to the
Receiver.
. W
e hoPe it brings you many
.
.