Heating Assembly & Thermostats - Splendide AS66VX Training Manual

S. HEATING ASSEMBLY & THERMOSTATS
1. Remove the right hand side panel as in
(F). NOTE: If only changing T-Stats go to
step 3.
2. Disconnect the wiring harness to the heater
assembly.
3. Remove the bearing cover.
4. Remove the 8 screws securing the heater
assembly to the rear panel.
5. Remove the 2 screws securing the element
and thermostats to the rear cover.
NOTE: If replacing the thermostats both
the cycling and on-shot thermostat
MUST be replaced should either fail.
NOTE: When installing the heater cov-
er, make sure the heater wiring is not
trapped between the inner and outer
rear panels. Also make sure the rear
heater cover is not hitting the blades of
the fan motor.
U REAR BEARING
1. Remove the drive pin.
2. Remove the bearing mounting screw.
3. Using a small screwdriver or similar, care-
fully remove the bearing from the bracket
on the rear of the control panel.
Dismantling Instructions
17