Rear Seal - Splendide AS66VX Training Manual

4. Note the wire locations and disconnect the
wires from the motor going to the capacitor.
5. Disengage the drive belt from the motor
shaft by turning the belt back and forth and
applying pressure towards the front of the
unit.
6. Remove the 3 hex head screws securing
the motor to the motor bracket.
7. Remove the 2 screws securing the motor
bracket to the bottom panel if necessary.
NOTE: When installing the heater cover,
make sure the heater wiring is not
trapped between the inner and outer
rear panels. Also make sure the rear
heater cover is not hitting the blades of
the fan motor.
16
Dismantling Instructions
R. REAR SEAL
1. Remove the drum as in (M).
2. Remove the rear seal and clean any rem-
nants of the seal and adhesive from the
inner face of the inner back panel. Fit the
new seal using high temperature silicone.