InFocus Table Top Installation

Table Top Installation

There are two methods of installation; ceiling and table top. We have listed and illustrated the steps that are required to conduct a table top installation. As you can see,
the there is very little installation time, knowledge and tools required to install a projector in this manner. If you prefer to have a more professional look, then we would
recommend either a ceiling installation or consulting with a local professional installer.

Advantages

+ Quick set up
+ Minimal tools required
+ Little or no calculations
+ Short cables = high quality video
+ Less expensive installation
+ Screen is optional
1
Install hooks or mounting brackets.
Hang the screen at desired location.
VGA RS-232
M1-DA S-video
4
Connect video cables to projector.
Copyright © 1999-2005 InFocus Corporation. All Rights Reserved.

Disadvantages

- Cables are visible
- People or pets can tamper with projector
- Easy to walk in light path
- Easy to trip over cables
Plug in the projector. With the InFocus logo
2
screen, move the projector away from the screen
until it approximately fits the projection screen.
Signal Output
Select
Remote
480p
480i
Component Composite
Y
Cable In
Pb
L
Pr
R
To TV/VCR
To projector
To video sources
5
Connect audio and video cables to sources.
Connect audio cables to speaker system.

Pre-installation Checklist

Equipment (projector, screen, audio, video, accessories)
Cables (audio, video and power)
Screen and projector location
Digital Video
Audio Out Analog Video Out
Out
Surround Sound Stereo Composite S-video Component
HDMI
DVI
Digital Digital L R Y Pb/Cb Pr/Cr
Optical Coax
Audio Out Analog Video Out
Digital Video Out
HDMI
Surround Sound Stereo Composite S-video
Component
DVI
Digital Digital L R
Y Pb/Cb Pr/Cr
Optical Coax
To audio receiver
3
Place projector on a flat sturdy surface, such
as a table or a shelf.
6
Install and test home theater equipment.