Krell Industries 700cx Instructions For Use Manual page 15

Back Panel Description
Notes
Note
Krell Full Power Balanced X Series Power Amplifiers
The back panel provides connections for all inputs and outputs,
power on/off, and remote control links. The back panel also has
handles that allow you to safely and easily move the amplifier.
13 Left and Right Loudspeaker Binding Posts
These amplifiers are equipped with four pairs of loud-
Stereo.
speaker binding posts (upper left, lower left, upper right, and
lower right).
Monaural. These amplifiers are equipped with two pairs of
loudspeaker binding posts.
Two pairs of loudspeaker binding posts are used for each channel of
amplification. On the stereo or monaural Full Power Balanced ampli-
fiers, either the upper or the lower pair can be used with loudspeakers
having two pairs of binding posts. For biwiring applications, with loud-
speakers having more than one pair of binding posts, use both upper
and lower pairs of loudspeaker binding posts. See the loudspeaker's
instruction manual for biwiring connections.
Loudpeaker binding posts for stereo and monaural amplifiers accept
spade lugs only. Bare wire, banana lugs, or pins will not work. Use the
red terminal for the positive connection and the blue terminal for the
negative connection.
14 Krell CAST Inputs
The Krell CAST inputs allow the Full Power Balanced amplifier to
be connected to the KPS 25sc Krell Playback System and other
CAST-equipped components.
Stereo. These amplifiers are equipped with one left Krell CAST
input and one right Krell CAST input via 4-pin bayonet connec-
tors.
Monaural. These amplifiers are equipped with one Krell CAST
input via 4-pin bayonet connectors.
15 Back Panel Power Breaker Switch
Place the back panel power breaker switch in the up position to
put the amplifier in stand-by mode.
Krell recommends that the amplifier remain on, in stand-by mode,
even when not in use, once it is powered on from the back panel
power breaker switch (15).
11