Preparing To Remove Components; Installing And Removing Memory Expansion - Fujitsu LIFEBOOK P8110 Operating Manual

Removing and installing components during servicing

Preparing to remove components

If you are going to remove or change system components, prepare for the removal as follows:
Please observe the safety information in chapter
Remove the power plug from the mains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► Remove the battery (see

Installing and removing memory expansion

Memorymodule Mainmemory System expansion System expansion Removing memory
If you are asked by the Hotline/Help Desk to remove and install the memory
expansion module yourself, proceed as follows:
Please observe the safety information in chapter
The notebook must be switched off when installing/removing memory modules
and it must not be in one of the power saving modes.
Only use memory expansion modules that have been approved for your
notebook (see
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
The memory module is located underneath the service compartment. You must open the service
compartment to remove or install a memory module. Once you have removed the cover,
the various components are exposed. These components should be removed and replaced
only by authorised specialists. Therefore, be sure to observe the following:
Individual components (e.g. the processor heat sink) can become very hot
during operation. Therefore, we recommend that you wait one hour after
switching off the notebook before removing or installing memory modules.
Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter
48
"Removing a battery", Page
"Technical data", Page
"Notes on installing and removing boards and components", Page
"Important notes", Page
25).
"Important notes", Page
62).
A26391-K218-Z200-1-7619, edition 1
5.
5.
47.