Table of Contents
Advertisement
Preparing to remove components
If you are going to remove or change system components, prepare for the removal as follows:
Please observe the safety information in chapter
Remove the power plug from the mains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► To switch off the battery and switch the device into a currentless state, press a
pen or a piece of wire (e.g. a paperclip) firmly into the opening in the battery
switch-off button on the underside of the device.
As soon as the device is supplied with voltage, the battery is switched on again.
Fujitsu
Removing and installing components during servicing
"Important notes", Page
12.
45
Advertisement
Table of Contents
