Toshiba teli BG030 Specification page 20

6.11 Connector pin assignment
Gigabit Ethernet interface connector
RJ-45 Jack
Pin No.
1
2
3
4
5
6
7
8
I/O Connector
Connector (Camera side)
Plug (Cable side)
Camera cable is not an accessory of this product.
Pin assignment
1 6
2 5
3 4
* Above figure is connector view from insert side.
Pin No.
1
2
3
4
5
6
Notes on Power Supply:
This camera has two ways of power supply,
- Supply from LAN cable (PoE)
- Supply from camera cable (DC+12V ±10%)
If both PoE and DC+12V are connected, power is supplied from PoE.
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
I/O Signal Name
I/O BI_DA+ / VDC+
I/O BI_DA- / VDC+
I/O BI_DB+ / VDC-
I/O BI_DC+ / VDC+
I/O BI_DC- / VDC+
I/O BI_DB- / VDC-
I/O BI_DD+ / VDC-
I/O BI_DD- / VDC-
I/O Signal Name
I +12V
I Line 0
O Line 1
O Line 2
- I/O GND
- GND
Bidirectional Data A (+) / Power (+)
Bidirectional Data A (-) / Power (+)
Bidirectional Data B (+) / Power (-)
Bidirectional Data C (+) / Power (+)
Bidirectional Data C (-) / Power (+)
Bidirectional Data B (-) / Power (-)
Bidirectional Data D (+) / Power (-)
Bidirectional Data D (-) / Power (-)
HR10A-7R-6PB(73) (Hirose) or equivalent
HR10A-7P-6S(73) (Hirose) or equivalent
18
Function
Function
Power
External Trigger Input
GPIO_0 Output
GPIO_1 Output
GPIO_Ground
Ground
http://www.toshiba-teli.co.jp/index.htm
D4211883D