Table of Contents
Advertisement
6. Install DIMM Modules
This motherboard has two 168-pin DIMM sockets that allow you to install PC100 or
PC133 memory up to 1.0GB.
7. Connecting IDE and Floppy Cable
Connect 34-pin floppy cable and 40-pin IDE cable to floppy connector FDC and IDE
connector. The blue connector is IDE1 for clear identification. Be careful of the pin1
orientation. Wrong orientation may cause system damage.
Pin 1
FDD Connector
DIMM1
DIMM2
Primary
Primary
Master (1st)
Slave (2nd)
IDE Connector
Pin 1
Secondary
Secondary
Master (3rd)
Slave (4th)
8. JP13 LAN Select Jumper (MX36LE-UN Only)
This jumper allows you to enable or disable the LAN onboard function by adjusting the
position of yellow cap.
1
Enable
Pin 1
9. Connecting Front Panel Cable
1
SPWR
ACPI &
IDE LED
+
+
Power LED
+
+
Speaker
Reset
IDE1 (Primary)
1
IDE2 (Secondary)
SPWR
NC
GND
NC
ACPILED-
+5V
GND
IDE LED
ACPILED
IDE LED
NC
+5V
NC
+5V
GND
GND
RESET
NC
GND
SPEAKER
1
Disable
Attach the power LED, ACPI, speaker, power and reset
switch connectors to the corresponding pins. If you enable
"Suspend Mode" item in BIOS Setup, the ACPI & Power
LED will keep flashing while the system is in suspend
mode.
Locate the power switch cable from your ATX housing. It is
2-pin female connector from the housing front panel. Plug
this connector to the soft-power switch connector marked
SPWR.
Advertisement
Table of Contents
