Graco GMax 232624 Instructions-Parts List Manual page 9

Pinion Assembly/Rotor/Shaft/Clutch/Pulley
Removal
If pinion assembly (8) is not removed from clutch
housing (3), do 1. through 4. Otherwise, do 1 and then
start at 5.
1.
Relieve pressure; page 4.
2. Disconnect field cable (X) from pressure control.
Bottom View
Fig. 5
3. Fig. 6. Remove five screws (5) and lockwashers
(6) and pinion assembly (8).
5
6
Fig. 6
4. Fig. 7. Place pinion assembly (8) on bench with
rotor side up.
5. Remove four screws (39) and lockwashers (6).
Install two screws in threaded holes (E) in rotor.
Alternately tighten screws until rotor comes off.
X
8739A
5
6
E
Fig. 7
6. Fig. 8. Remove retaining ring (Z).
7. Tap pinion shaft (A) out with plastic mallet.
Fig. 8
8. Fig. 10. Remove drive belt shield (74) and
8
belt (68).
9. Hold pulley (2) and remove four screws (3a) and
washers (3h) from hub (3d). Remove armature
(3g) and spacer (3f).
10. Remove set screw (112a) from bushing (112).
Remove three bolts (112b) and three washers
(112c). Use bolts to remove pulley from bushing.
8740A
Remove pulley and key (1).
11. Remove three screws (27) from beneath mounting
plate (D).
12. Lift off clutch housing (3).
13. Remove retaining ring (3b). Pull jack shaft assem-
bly (3c) out.
39
6
Z
A
308864
8701A
8703A
9