Table of Contents
Advertisement
Removal
1. Flush pump.
2.
Relieve pressure; page 4.
3. Fig. 12. Cycle pump with piston rod (222) in its
lowest position.
4. Fig. 12. Remove suction tube (107) and hose (47).
47
Fig. 12
5. Fig. 13. Use screwdriver: push retaining spring up
and push out pin (19).
Repair
See manual 308798 for pump repair instructions.
Installation
WARNING
If pin works loose, parts could break off due to
force of pumping action. Parts could project
through the air and result in serious injury or prop-
erty damage. Make sure pin and retaining spring
are properly installed.
CAUTION
If the pump jam nut loosens during operation, the
threads of the bearing housing will be damaged.
Make sure jamnut is properly tightened.
1. Fig. 15. Pull piston rod out 1.5 in. Screw in pump
until holes in bearing cross link and piston rod
align.
Fig. 15
14
308864
Displacement Pump
222
107
7672B
1.5 in.
7676B
Fig. 13
6. Fig. 14. Loosen jam nut by hitting firmly with a
20 oz (maximum) hammer. Unscrew pump.
Fig. 14
2. Fig. 13. Push pin (19) into hole. And push retaining
spring into groove all the way around connecting
rod.
3. Fig. 16. Screw jam nut down onto pump until
stops. Screw pump up into bearing housing until it
is stopped by jam nut. Back off pump and jam nut
to align pump outlet to back. Tighten jam nut by
hand, then tap 1/8 to 1/4 turn with a 20 oz (maxi-
mum) hammer to approximately 75 5 ft--lb (102
N¡m).
Fig. 16
4. Fig. 17. Fill packing nut with Graco TSL, through
one of the slits, until fluid flows onto the top of
seal.
Fig. 17
19
7675B
7673B
7673B
7677B
Hide quick links:
Advertisement
Table of Contents
