• If you switch on your Dreambox for the first time, you will see the setup wizard.
The setup wizard will guide you through the first time installation. Follow the instructions on the screen.
See chapter 3. Start wizard.
• Please note that the factory setting for the video format is CVBS (FBAS).
3. Start wizard
The start wizard helps you with the basic setup of your Dreambox.
3.1 Video output selection
You will be shown different video output modes for roughly 10 seconds, after you have connected and
switched on your Dreambox. Once you see a clear picture on your TV screen press the OK-Button to select it.
If you prefer a different output than the selected one you can use the Navigations-Buttons up/down and the
OK-Button to select it.
-16-
You can choose from the following video output options:
1. DVI
using a DVI or DVI-to-HDMI cable
2. Scart
using a Scart cable
3. YPbPr (YUV)
using a component cable
Select your desired option with the Navigation-Buttons up and
down. Press the OK-Button to activate.
You are taken to the next step.
You can now select the video mode.
The possible options strongly depend on the video output mode
you have selected in the step before. To learn more about the op-
tions refer to chapter 11.4 Audio / Video.
Select your desired option with the Navigation-Buttons up and
down. Press the OK-Button to activate.
You are taken to the next step.