Unloading Nailer; Adjusting Depth Of Nailing - Makita AF631 Instruction Manual

Unloading nailer
CAUTION:
Always disconnect the air hose before unloading the nailer.
Pull the pusher fully to the rear and depress the lock button.
While
keeping
the
lock button depressed, release your finger
from the pusher to lock the pusher with the lock button.
Point the rear of the magazine downward to remove the
strip of nails from the magazine.
If the strip
of
nails cannot be removed because it
is
caught
by the pusher, depress the pusher tab to disengage the strip
of nails from the pusher and remove it from the magazine.
L L o c k button
1
To unlock the pusher, pull it to the rear again.
Adjusting depth of. nailing
CAUTION:
Always disconnect the air hose before adjusting the depth of nailing.
T o adjust the depth of nailing, press the knob toward the
nose tip and turn the adjuster so that the arrow above the
adjuster will point to the number indicated on the adjuster.
The depth of nailing
is
the deepest when the arrow points
to the number 1. It will become shallower as the arrow
points to higher number. The depth can be changed in
approx. 0.8 mm (1/32") increments per graduation. If nails
cannot be driven deep enough even when the arrow points
to the number 1 , increase the air pressure. If nails are driven
too deep even when the arrow points to the number 9,
decrease the air pressure.
Adjuster Knob
I