Installing Or Removing Driver Bit Or Drill Bit; Storage Of Driver Bit; Switch Action; Reversing Switch Action - Makita 6075D Instruction Manual

Installing or removing driver bit or drill bit
CAUTION :
Always
be
sure that the
tool
is switched
off
and the battery cartridge
is removed before
installing or removing the bit.
Hold the ring and
t u r n
the sleeve counter-
clockwise to open the chuck jaws. Place
the bit
in
the chuck as
f a r
as it
will
go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To
remove the bit, hold the ring and turn
the sleeve counterclockwise.
Storage of driver bit
When not using the driver bit, keep it
in
the storage cavity on the tool.
CAUTION
:
Before inserting the battery cartridge into the tool, always check t o see that the trigger
switch actuates properly and returns to the "OFF"
position when released.
Reversing switch action
This tool has a reversing switch
to
change
the direction of rotation. Slide the revers-
ing switch to the right for clockwise rota-
tion
or to
the left for counterclockwise.
CAUTION
:
Always check the direction of rotation before operation.
*Use the reversing switch only when the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
I