Quick Start - Metrologic MS6720 Installation And User Manual

Q S
UICK TART
1. Plug in the scanner. The red LED will come on, the green LED will
flash once and the unit will beep simultaneously.
2. The scanner is shipped from the factory programmed with default
settings. To configure the MS6720 scanner to meet the host system's
specific needs, refer to the ScanSelect
[ 00-02186] or the help files provided with MetroSet2 for
MLPN
instructions on how to enter the program mode and to select the
appropriate bar codes.
Note: Any time the Load Defaults bar code is scanned the MS6720 is
configured for an RS-232 interface. If a RS-232 is not being
used, scan at least one other bar code to enable Keyboard
Wedge, OCIA, Light Pen or 46xx.
®
Programming Guide
3