Table of Contents
Advertisement
GB
INSTALLATION
PARTS TO INSTALL
Wheels
Handle
TOOLS FOR INSTALLATION
WHEELS/CUTTING HEIGHT (fig. 1)
1. Press the wheel bolt A into the wheel cap B.
2. Snap centre cap C in place.
3. Install the wheel in one of the mounting plate's
four positions.
4. Tighten properly by hand with the aid of the fin-
ger grip in the wheel cap.
Note! The same cutting height should be set for all
wheels.
6
ENGLISH
HANDLE (fig. 2)
1. Press one handle tube down into the mount on
the left-hand side (see picture).
2. Push on the upper part of handle.
3. Turn the entire handle in the opposite direction
(see picture).
4. Insert the other handle tube into the upper part.
5. Press the handle tube down into the mount on
the right-hand side.
6. Turn back the entire handle until straight.
7. Fit the screws. Tighten properly.
8. Secure the electric cable with a cable tie.
GRASS COLLECTOR (fig. 3)
Snap together the grass collector's upper and lower
sections.
Open the flap on the machine and attach the grass
collector to the chassis.
Note! The lawnmower can be operated without the
grass collector. The grass is then left in a line be-
hind the machine.
USING THE LAWNMOWER
CONNECTION (fig 4)
Only use an extension cable approved for outdoor
use with a maximum length of 50 metres and no
lighter than type 245 IEC 53 (H05RR-F) or 227
IEC 53 (H05VV-F). If you are in any doubt, con-
tact your dealer.
Relieve the load on the cable in the cable holder on
the handle.
START / STOP (fig. 5)
Start the lawnmower on a flat, firm surface. Do not
start in long grass. Press the handle down so that
the front wheels are raised slightly from the ground
to reduce grass resistance
Starting the motor:
1. Press the button.
2. Squeeze the handle towards the handlebar.
Stopping the motor: Release the handle.
CUTTING (fig. 6)
Always cut away from the lead.
Advertisement
Table of Contents
