Assembly Instructions - Scheu Products Company SPC-54PHW Owner's Manual

SPC-54PHW SPC-54PHB SPC-54PHT SPC-55PHS

ASSEMBLY INSTRUCTIONS

Figure 13
Figure 14
Models
Step 11
Attach Dome to Emitter (Figure 13 ).
Gently lay Heater Assembly on its side using one of
the shipping styrofoam inserts to prop up the top half of
the heater. Align holes in Dome with threaded studs in
Emitter Cover. Secure Dome to Emitter using (3) Cap
Nuts and tighten them with an adjustable wrench.
Stand the heater upright.
Step 12
FOR SPC-55PHS ONLY
Battery installation (Figure 14)
Battery is only provided for SPC-55PHS inside the hardware
bag.
1. Look at the front panel of the burner/control assembly
and locate the red button.
2. Turn the red button counter clockwise.
3. Install the battery in the burner/control assembly with
the flat surface of the battery inside the unit.
4. Install the red button and make sure it is mounted
tightly.
5. Push the red button. You should hear a ticking sound.
If not, repeat step 1 through 4.
Page -9-