SPC-54PHW SPC-54PHB SPC-54PHT SPC-55PHS
ASSEMBLY INSTRUCTIONS
Figure 5
Figure 6
Models
Secure Pole Support to Legs using (6) Large Bolts. (6)
tighten the nuts and bolts from Step 1. (Figure 3)
Attach Ballast Weight to Base using (1) Long Bolt, (1)
Large Lock Washer and (1) Large Nut. (Figure 4)
Step 4
Insert Manifold into Pole Support (Figure 5 & 6).
Insert the Manifold Assembly through the Post by
passing through the hole in the Post Support.
NOTE: Make sure the hose and regulator assembly
attached to the manifold is never bent or kinked during
the installation and operation of the heater.
Page -6-