Figure; Step - Scheu Products Company SPC-54PHW Owner's Manual

SPC-54PHW SPC-54PHB SPC-54PHT SPC-55PHS

Step 9

FIRST ASSEMBLY CHECK FOR LEAKS
The heater must be leak tested before any further assembly is done. Use only a soap and water solution.
DO NOT USE FLAME.
Turn the Control Knob to the "OFF" position. Securely connect the Regulator to the Propane Gas Cylinder. Open
the Propane Cylinder valve. Apply a dishwashing soap (1-part) and water solution (3-parts) to the connection at the
Manifold and Burner & Control Assembly. Bubbles will form if the connection is leaking. In the case of any leaks, turn
off the Propane Cylinder valve, remove the Manifold, and check and clean connection. Reconnect the Manifold and leak
test again. If the leak persists, do not return heater to the store. Please call toll-free 1-888-619-7060 or e-mail
technicalservice@allpro-heaters.com for assistance and advice.
Upon completion of the leak test, and there is no sign of a leak, turn off the Propane Cylinder Valve and disconnect
the Regulator from the Propane Gas Cylinder then remove the Propane Gas Cylinder and continue to the next step.

Figure 11

Figure 12
Models
ASSEMBLY INSTRUCTIONS
1. Look underneath post support. There will be a threaded
2. Align the holes on manifold fixing plate with the
3. Make sure manifold fixing plate is facing downward.
4. Use (1) medium bolt to tighten manifold fixing plate with
5. Turn the manifold fixing plate so it will hold the manifold
6. Tighten the medium bolt so the manifold fixing plate will
7. Slide cylinder cover into place.
Step 9
Attach Pole to Burner & Control Assembly (Figure 11).
Align the 3 holes; insert (3) small bolts and tighten
using #2 Philips head screwdriver.
Step 10
Attach Manifold fixing plate to Pole Support
(Figure 12).
hole to mount manifold fixing plate.
threaded holes on the pole support.
(Figure 12).
the post support using #2 Philips head screwdriver.
in place.
not move.
Page -8-