Safety Precautions; Operating Precautions - Scheu Products Company SPC-54PHW Owner's Manual

SPC-54PHW SPC-54PHB SPC-54PHT SPC-55PHS

OPERATING PRECAUTIONS

This is a propane, direct-fired heater.
Propane is heavier than air. If propane leaks from a connection
or fitting, it sinks to the floor, collecting there with the
surrounding air, forming a potentially explosive mixture.
Obviously, propane leaks should be avoided, so set up the
propane supply with utmost care. Read enclosed Odor Fade
and Propane Sheet for additional information about detecting
propane leaks. Leak check new connections or reconnections
with a soap and water solution and follow all connection
instructions herein. Also, ask your propane dealer for advice on
the propane application and supply installation and ask him to
check it if there are any questions.
Direct-Fired means that all of the combustion products enter the
heated space. Even though this heater operates very close to
100 percent combustion efficiency, it still produces small
amounts of carbon monoxide. Carbon monoxide (called CO) is
toxic. We can tolerate small amounts but not a lot. CO can build
up in a heated space and failure to provide adequate ventilation
could result in death. The symptoms of inadequate ventilation
are:
headache
burning eyes and nose
dry mouth or sore throat
So, be sure to follow advice about ventilation in these operating
instructions.
When the heater is to be operated in the presence of other
people the user is responsible for properly acquainting
those present with the safety precautions and instructions,
and of the hazards involved.

SAFETY PRECAUTIONS

1. Check the heater thoroughly for damage. DO NOT operate
a damaged heater.
2.DO NOT modify the heater or operate a heater which has
been modified from its original condition.
3.Use only propane gas.
4.Use only VAPOR WITHDRAWAL propane supply. The
propane cylinder must be arranged for vapor-withdrawal,
in accordance with the Compress Gas Associations,
Small Propane Bottle Assembly. If there is any question
about vapor withdrawal, ask your propane dealer.
5.Never use the heater if the ballast weight is not assembled
onto the base. The base must be weighted to avoid
tipping.
6.IMPORTANT. Use only the hose and regulator assembly
provided with the heater. Match the color stripe on the
hangtag attached to the hose assembly with the color on
the label located near the propane inlet fitting on the
heater. Inspect hose assembly before each use of the
heater. If there is excessive abrasion or wear, or hose is
cut, replace with hose assembly listed on parts list before
using heater.
7.This heater is for OUTDOOR USE ONLY, even so, make
sure that there is ample fresh air ventilation. Do not use in
buildings, garages or other enclosed spaces.
Models
10. Maintain minimum clearance to people or normal
11. Due to the high surface and exhaust temperatures, adults
12. Operate only on a stable, level surface.
13. Do not hang or attach clothing or any other combustible
14. Do not spray aerosols near the heater during use or shortly
15. Do not clean heater with combustible or corrosive cleaners.
16. Check control compartment burners and circulation air
dizziness
nausea
17. Use only soapy water (1-part liquid dishwashing detergent to
18. Do not adjust gas regulator. If you are unsure of your
19. Place the control knob on "OFF" position when heater is not in
20. Always disconnect the gas supply after the heater is turned
21. Care must be taken for the supervision of children and
22. Do not move, handle or service while hot or burning.
23. Allow 45 minutes to cool down after use before attempting to
24. Do not operate this appliance in windy conditions. Maximum
25. Do not operate this appliance in temperature conditions
26. Keep heater away from areas where flammable liquids,
27. If operated in salt air environments, the unit will require more
28. Items or material, when stored under the heater, will be
29. Use only in accordance with local codes, or in the absence of
8. If at any time gas odor is detected, IMMEDIATELY
DISCONTINUE operation until the source of gas has been
located and corrected. Read enclosed Odor Fade and
Propane Sheet for additional information about detecting
propane leaks.
9. Install the heater such that it is not directly exposed to water
spray, rain and/or dripping water.
combustible material (like paper) of 3.6 ft. (1100mm) from top
and 2 ft. (609mm) from the reflector.
and children must observe clearances to avoid burns or
clothing ignition.
materials from, on or near the heater.
thereafter.
Use warm, soapy water.
passageways for free air passage, make sure that there are
no obstructions. These areas are a common location for
spider webs, which can present a dangerous condition,
damage the heater and render it unsafe for use. The heater
must be checked if any of the following conditions exist:
a) Gas smell along with predominate yellow tipping of the
burner.
b) Heater does not reach temperature.
c) Uneven burner glow.
d) Burner makes popping noises during normal use,
other than during shutdown.
3-parts water) to conduct Leak Tests whenever a propane
cylinder is connected. Bubbles indicate a leak.
appliances gas type or pressure, call out a gas fitter or
plumber.
use.
"OFF".
animals in the vicinity of an operating heater.
move heater.
allowable wind speed is 10MPH (16Km/h).
below 40°F (5°C).
vapors or solids are stored or used.
frequent cleaning; otherwise, the longevity of the unit will
deteriorate rapidly. Use warm soapy water to clean the unit.
subjected to radiant heat and could be seriously damaged.
local codes, with the National Fuel Gas Code ANSI Z223.1.
Warning: For Outdoor Use Only
Page -3-