Tilt Steering Wheel - Toyota Sienna Operating Manual

308 mm
Bolt
(12.1 in.)
Anchor
bracket
Spacer
543 mm
(21.4 in.)
Center line
Third seat
86
On the floor behind the rear seat
a. Using the illustration as a guide, find
the slits on the floor carpet to locate the
position of the holes underneath.
b. Make a hole in the covering directly
above the hole in the floor.
c. Insert a 15 mm (0.6 in.) spacer and
tighten down the anchor bracket for your
child restraint system with a bolt. Torque
the bolt to 16.5—24.7 N m (1.68—2.52
kgf m, 12.2—18.2 ft lbf).
To comply with Canada Motor Vehicle
Safety Standards, vehicles sold in Canada
are provided with a bracket set in the
glovebox, designed for use with any of the
4 anchor locations shown in the illustra-
tion.
If your child restraint system does not
provide any of the necessary parts, ask
your Toyota dealer. (See "—Child restraint
system".)
name. SIENNA (U)

Tilt steering wheel

To change the steering wheel angle,
hold the steering wheel, pull the lock
release lever toward you, tilt the steer-
ing wheel to the desired angle and re-
lease the lever.
When the steering wheel is in a low posi-
tion, it will spring up as you release the
lock release lever.
CAUTION
"
Do not adjust the steering wheel
while the vehicle is moving.
"
After adjusting the steering wheel,
try moving it up and down to make
sure it is locked in position.