Replacing Light Bulbs - Toyota Corolla 1998 Operating Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
1998 COROLLA(U)
Bulb
Light bulbs W
No.
Headlights HB2 60/55
Parking, front side
marker and front 3157NA 27/8
turn signal lights
R e a r s i d e m a r k e r
194 3.8
lights
Rear turn signal
3156 27
lights
Stop and tail lights 3157 27/8
Back- up lights 921 18
License plate lights 194 3.8
High mounted
18
—
stoplight
Personal light 10
—
Interior light — 8
Trunk light 194 3.8
A: HB2 halogen bulbs
B: Single end bulbs
C: Wedge base bulbs
D: Double end bulbs
—Headlights
Type
A
C
C
C
C
C
C
1. Open the hood.
C
RIGHT- HAND HEADLIGHT:
B
the bolts and take out the relay
D
block.
C
Put the relay block in the appropriate
place other than on the engine.
NOTICE
Do not place the relay block on the
engine.
Remove
197